Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
documentation:coreboard:start [2022/01/06 04:31]
gregk
documentation:coreboard:start [2022/03/09 11:10] (current)
gregk
Line 6: Line 6:
 The instructions below explain the steps required to allow a trouble-free installation of your NLD Mavic 2 Core Board. You must follow all of the steps below to ensure a stable flight. The instructions below explain the steps required to allow a trouble-free installation of your NLD Mavic 2 Core Board. You must follow all of the steps below to ensure a stable flight.
  
-{{:documentation:coreboard:coreboard.png?400|}}+ 
 + 
 +<figure board> 
 +{{ :documentation:coreboard:coreboard.png?400 |}} 
 +<caption>**Core Board Connectors**</caption> 
 +</figure> 
  
 ==== Legend ==== ==== Legend ====
Line 22: Line 28:
  
 The flex cable connectors are delicate and may break if they are poorly aligned, and you apply force. The connectors need to be seated correctly be allowing your finger to roll from side to side without using force until correctly seated. Verify by looking at the connector from the side and confirming that it is level with the socket and not tilted at an angle. The flex cable connectors are delicate and may break if they are poorly aligned, and you apply force. The connectors need to be seated correctly be allowing your finger to roll from side to side without using force until correctly seated. Verify by looking at the connector from the side and confirming that it is level with the socket and not tilted at an angle.
 +
 +<figure incorrect>
 +{{ :documentation:coreboard:notcorrectplaced.jpg?400 |}}
 +<caption>**Not correctly placed**</caption>
 +</figure>
 +
 +<figure correct>
 +{{ :documentation:coreboard:correctlyplaced.jpg?400 |}}
 +<caption>**Correctly Placed**</caption>
 +</figure>
  
 We have some additional steps that we recommend when installing your new board, to help ensure success and to make it easy for us to help you if you get stuck. Basically, install the connectors in the order listed in the legend. But we will do a few extra checks along the way. We have some additional steps that we recommend when installing your new board, to help ensure success and to make it easy for us to help you if you get stuck. Basically, install the connectors in the order listed in the legend. But we will do a few extra checks along the way.
Line 44: Line 60:
  
 Open up DJI Assistant and perform a Visual Calibration before performing any flight. The board comes without calibration data, and therefore it is required before taking off. Open up DJI Assistant and perform a Visual Calibration before performing any flight. The board comes without calibration data, and therefore it is required before taking off.
 +
 +{{youtube>Mum2h31g2pc?large}}
 +
 +{{youtube>XdGtZBrIe9A?large}}
  
 ===== 3. IMU and Compass Calibration ===== ===== 3. IMU and Compass Calibration =====
 Open up the DJI GO 4 Application and calibrate the IMUs and the Compass. Open up the DJI GO 4 Application and calibrate the IMUs and the Compass.
 +
 +{{youtube>rOWD_OfOROI?large}}
  
 ===== 4. Gimbal Calibration ===== ===== 4. Gimbal Calibration =====