NLD MAVIC 2 FIRMWARE DOWNGRADE

!!! IMPORTANT PLEASE READ BEFORE USE !!!

Thank you for your order!

We are delighted to provide this downgrade option, and we hope you will have a smooth ride using your Mavic 2 Zoom/Enterprise Main Board.

Swapping this board with the original board is not complicated. However, we recommend viewing the Mavic 2 Zoom/Pro disassembly video on YouTube shown below if this is your first time doing a board swap.

The instructions below explain the steps required to allow a trouble-free removal and re-installation of your Mavic 2 Core Board. You must follow all of the steps below to ensure a stable flight.

Follow the teardown video to remove your existing board and install the new board.

The flex cable connectors are delicate and may break if they are poorly aligned, and you apply force. The connectors need to be seated correctly be allowing your finger to roll from side to side without using force until correctly seated. Verify by looking at the connector from the side and confirming that it is level with the socket and not tilted at an angle.

Open up DJI Assistant and perform a Visual Calibration before performing any flight. The board comes without calibration data, and therefore it is required before taking off.

Open up the DJI GO 4 Application and calibrate the IMUs and the Compass.

Also, with the DJI GO 4 Application, perform the Gimbal calibration to avoid tilted or shaky gimbal.

Open up the NLD Windows application and apply the modifications needed.

Your board is now on version 01.00.0100, which works with our mods.

If you upgrade your firmware again, you will lose all of your mods, and the only way to get back will be to send the board back to us.